Sari la conținut
bbh_blocked_dnftl
  • GTC-banner-728.jpg.5cc46ba09a7dd8e0286229917ccf417d.jpg

  • GTC-banner-300.jpg.0de16ddb1a65d423b7281e32d9bd2e76.jpg

Freelander 2, 2010, hse - cod eroare p0299


PopaDan

Postări Recomandate

Salut! Am un Freelander 2 din 2010 varianta hse. Si ma confrunt cu o problema si mai exact cu un cod de eroare p0299. Mentionez ca am facut turbina si am schimbat intercooleru, plus senzorii de presiune. Poate ma ajuta cineva cu niste sfaturi. Multumesc!
Link spre comentariu
Distribuie pe alte site-uri

Re: Land Rover

 

Daca s-a facut citirea cu un tester multimarca :

 

P0299 code definition

 

P0299 is a generic OBD-II diagnostic trouble code indicating an underboost condition.

What the P0299 code means

 

The P0299 code indicates that the Turbo or Supercharger "A" has excessively low output. The ECU looks for a specific range of boost and when the low boost is detected by the ECU, it sets a P0299 code.

This code will illuminate a Check Engine Light on the dashboard and may put the vehicle in limp mode. The limp mode is to prevent further damage to the vehicle and will remain until the code is cleared or repaired.

What causes the P0299 code?

Faulty turbo or supercharger

Low oil pressure in the engine

Fault in the EGR system

Air or intake leak or restriction

Faulty boost pressure sensor

What are the symptoms of the P0299 code?

Check Engine Light is illuminated

Some vehicles may go into a limp mode

Lack of engine power

Mechanical noise (failing turbo / supercharger)

How does a mechanic diagnose the P0299 code?

A mechanic will begin by hooking up a scan tool into the vehicle's OBD-II port and checking for any codes present.

The technician will note all freeze frame data, which will have information about what conditions the vehicle was under when the code was set.

The codes will then be cleared and a test drive performed.

Next, a visual inspection will be performed of the turbo / supercharger system, intake system, EGR system, and any other associated systems.

After, the scan tools will used to check for proper boost pressure readings.

All mechanical systems will be inspected such as the turbo or supercharger itself, oil pressure and the intake system for leaks or restrictions.

Common mistakes when diagnosing the P0299 code

 

Mistakes can be made if all steps are not followed in the proper order are are not completed at all. P0299 can have a wide variety of symptoms and causes. Following the diagnostic steps properly and in the right order is important for accurate diagnosis.

How serious is the P0299 code?

 

The presence of the P0299 code can point to some rather serious mechanical failures, especially if left unaddressed. If any mechanical noise or drivability concerns are present, then the vehicle should be repaired as soon as possible. If a turbo charger unit fails and the vehicle is driven it can result in costly engine damage.

What repairs can fix the P0299 code?

Turbo or supercharger replacement

Repairing of the intake system

EGR replacement

Boost pressure sensor replacement

Low engine oil pressure repair

Additional comments for consideration regarding the P0299 code

 

When a turbocharger fails it can cause a piece of the turbine to become sucked into the engine. If a sudden loss of power is observed along with a mechanical noise stop the vehicle in a safe location immediately.

Reading the Owners Manual doesn't hurt.

NU RASPUND PE PM LA PROBLEME TEHNICE SAU DE INTERES GENERAL

Td4 ESX CommandShift MY02 3Dr (M.O.D.)

KV6 CommandShift MY01 3Dr (Măgaru')

SD4 S CommandShift MY11 5Dr (Sarah)

KV6 XEI CommandShift MY01 5Dr (Phoenix)

 

Link spre comentariu
Distribuie pe alte site-uri

×
×
  • Creează nouă...

Informații Importante

Accesul pe Forum Club4x4 este conditionat de respectarea Regulamentului - Termeni de Utilizare